rayjet manager dont recognise cutting job
Bug #1806251 reported by
Marion
This bug affects 1 person
| Affects | Status | Importance | Assigned to | Milestone | |
|---|---|---|---|---|---|
| Inkscape |
New
|
Undecided
|
Unassigned | ||
Bug Description
Hello,
I use a 30W Rayjet lasercut made by Trotec.
Rayjet mini manager software normally detects the cutting job with 0,01mm line in RGB red.
It works fine with Libre Office draw or Corel Draw.
Bug :
1- Rayjet manager doesn’t detect the red line as cutting job on Inkscape files, but as engraving job
2- When 0,01mm, the line isn’t visible with human eye on Inkscape, what makes the work difficult.
Bug was observed on every computers tried.
Please find attached a doc with screen caps.
Version of inkscape used: Inkscape 0.92.3 (2405546, 2018-03-11)
Version of rayjet mini manager: 2.4.0.7
Thanks for your work!
Marion (France)
Revision history for this message
| Marion (mariondu) wrote | #1 |
Revision history for this message
| Alvin Penner (apenner) wrote | #2 |
Revision history for this message
| Alvin Penner (apenner) wrote | #3 |
To post a comment you must log in.
- which OS are you using?
- have you tried the menu option: View->Display Mode->Outline, which will make even thin lines visible?
- do you mean that a 0.01mm line will cut properly?