Comment 4 for bug 948849
Revision history for this message
| Aleksandar Todorovic (1aleksandar-t) wrote | #4 |
© 2004
Canonical Ltd.
•
Terms of use
•
Data privacy
•
Contact Launchpad Support
•
Blog
•
Careers
•
System status
•
bbfa235
demo site
(Get the code!)
Yesterday i've updated plotter's firmware - same error massage on display 61:01! Looked at service manual. It says:
System Error: 61:YZ
Problem Description: The file format is incorrect or not supported for the current printer configuration and the printer
cannot process the job.
Corrective action: Try the following:
1. Check whether the printer supports the file format (formats such as PS, PDF, TIFF and
JPEG are supported by PostScript printers only).
2. Switch the power off from the back of the printer and disconnect the power cord.
Reconnect the power cord and power on the printer.
3. Check the graphic language setting of the printer (refer to the User's Guide).
4. Resend the file to the printer.
5. Check that the printer has the latest firmware version. If not, update the firmware to the
latest version.
...so what i did next was to change graphic language settings. But there are only two settings for this: Automatic and HP-GL/2. So i switched to HP-GL/2. After this my plotter DO some instructions (some efort taken) but nothing comes out... Really anoying